Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Brownsville
If your chimney crown is cracked or your cap has blown loose, you’re in the right place. We handle cap and crown work for Brownsville’s brick rowhouses and tenement buildings, and we know how these roofs actually sit: tight to the party wall, crowded with flues, and often venting more than one appliance. That changes how a cap or crown job gets planned. Call (833) 858-5823. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Brownsville Homeowners Call Chimney Sweep Crown Heights for Chimney Cap & Crown
We work in chimneys and fireplaces only. That focus matters on Brownsville blocks, where the chimney you see from the street rarely tells the whole story. A single masonry stack can serve a cellar boiler and a rooftop water heater at the same time, and in many buildings a leftover oil flue pipe from a later-’90s gas conversion is still connected to the stack. A cap sized for one opening leaves the other terminations open to rain, squirrels and downdraft. We trace every appliance tied into the chimney before we measure anything.
Our technicians have up to 10 years of experience, and they handle the sweep, the inspection, the cap and the crown as one job, not three separate visits from three different trades. No subcontracting for common repair work. Our customers in Brownsville tell us the same thing: they want someone who knows the difference between a shallow mortar wash and a real cast crown, and who can show them why.
We serve the neighborhood from Crown Heights, a short run across Eastern Parkway, so getting to a Brownsville address is quick. That proximity helps on the tight one-way blocks and the four- and six-story walkups where roof access takes planning.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Brownsville
Here’s what the work involves on Brownsville’s housing stock. Every job starts with a look at the whole stack, not just the opening you can see from the street.
Multi-Flue Cap Installation in Brownsville
A tenement chimney rarely serves one appliance. We fit multi-flue caps sized to each termination on the stack, so the boiler, the water heater and any older tie-in each get the coverage they need. On Brownsville’s attached brick rows, that means measuring every flue on the chimney crown before the cap goes on, not after.

Chimney Cap Replacement in Brownsville
Old caps on Brownsville roofs take a beating. Freeze-thaw winters crack the top plate, and squirrel and pigeon pressure works the fasteners loose. We pull the failed cap, check the flue terminations underneath for nesting or debris, and set a replacement cut to fit the actual opening, not a stock size that sits askew.

Crown Repair for Brownsville Rowhouses
The original crown on most Brownsville rowhouses is a thin mortar wash, and decades of New York winters have cracked it. Once water gets in, it runs down an unlined terra-cotta flue that was never sized for a later gas boiler, and you see the result as spalling brick and rusted flashing at the party wall. We break out the failed wash and cast a proper overhanging crown that sheds water away from the flue.

Crown Coating in Brownsville
Not every crown needs to come out. Where the masonry is sound but the surface has pitted, we coat it with a flexible, purpose-made material that seals hairline cracks. Crown coating buys years on a tenement crown that hasn’t yet failed all the way through.
Trusted Brands We Service in Brownsville
Cap and crown work is only half the flue story, so we keep everything we need in the same trade. We use a vetted roster of professional-grade brands: HeatShield for ceramic flue resurfacing, Gelco and Olympia Chimney for cap and crown components, and Famco for venting. These are the same lines chimney professionals use across the country. When a cap job turns up a cracked terra-cotta liner underneath, we can address it in the same visit and keep the turnaround short instead of bringing in a second contractor.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in Brownsville Homes
- Thin mortar crowns that crack and spall. The original wash on an early-20th-century Brownsville rowhouse was never built to last a century of freeze-thaw. When it cracks, meltwater runs straight down an unlined terra-cotta flue that wasn’t sized for a later gas boiler.
- Single-flue caps on stacks venting two appliances. This is the most common miss on Brownsville tenement roofs. A cap gets fitted for the boiler and the rooftop water heater termination is left open to rain and animal nesting.
- Cross-contamination across a shared party wall. Adjoining flues in a party-wall chimney can let a neighbor’s exhaust migrate through a cracked terra-cotta divider. A cap job done without tracing every tie-in masks that problem instead of fixing it.
- Leftover oil flue pipe after a gas conversion. Inspectors routinely find a later-’90s gas conversion left the original oil flue pipe still connected to the stack. Cleaning and capping require identifying every appliance tied in before the work starts.
Pricing for Chimney Cap & Crown in Brownsville, NY
Pricing below is typical for Brownsville’s market. It’s an estimate, and the written price for your job is set once we’ve seen the stack.
- Single or multi-flue cap, installed: $250 – $650, more for a custom cap on an irregular opening
- Crown repair or recast: $450 – $1,200
- Crown coating (sealing a sound crown): $250 – $550
- Cap replacement, removing the old unit: $300 – $700
- Flue resurfacing with HeatShield, when the liner underneath is cracked: $1,200 – $2,800
What moves the number: how many appliances vent into the stack, whether the crown needs a full recast or just coating, and roof access on a tall walkup. The estimate is free, and anything we recommend comes with camera evidence you can see for yourself before you agree to it.
We Also Serve Cities Near Brownsville
Brownsville shares its housing stock with the neighborhoods around it, so the same cap and crown problems show up just over the line. We also work in East Flatbush, East New York, Canarsie and Crown Heights. If you’re not sure where the boundary falls, call and we’ll sort it out. You can also read more about Brownsville and how we work the roofs here, or jump to our full Chimney Cap & Crown service page for the complete rundown.
Serving Brownsville, NY – Our Local Coverage Area
We serve Brownsville and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Brownsville
Yes, but only if the cap is a multi-flue unit sized to each termination on the stack. A single-flue cap fitted to one opening leaves the other appliance’s termination wide open to rain, squirrels and downdraft. That’s why we trace every appliance on the stack before we measure. Call (833) 858-5823 to book an inspection; the estimate is free.
Water is getting into the crown. When a thin mortar wash cracks in Brownsville’s freeze-thaw winters, meltwater runs down the flue and works its way out through the brick and flashing at the party wall. Left alone, that spalling gets worse each season. A recast crown stops it at the source; call (833) 858-5823 for an exact quote.
It can, if the cap is undersized or closed off too tight for the appliances venting into the flue. On an old unlined terra-cotta stack serving a gas boiler, the cap has to allow proper exhaust flow. We size it to the appliances, not to a stock measurement. Call (833) 858-5823 to have your stack assessed.
Usually, yes, because a cap over a cracked liner just covers the problem. In Brownsville’s tenement stock, cracked terra-cotta is common, and a liner serving a boiler plus a water heater needs to be sound before capping. We use HeatShield ceramic resurfacing to repair the liner when the flue is still structurally intact. Call (833) 858-5823 for an exact quote.
Once a year is the standard for a chimney that sees regular use, and it’s worth a look after any hard winter. Brownsville’s older crowns take real freeze-thaw stress and the caps take wind and animal pressure. Annual inspection catches a cracked crown before it turns into spalling brick. Call (833) 858-5823 to book.
If your cap is loose, your crown is cracked, or you’re not sure what’s venting into that shared Brownsville stack, call (833) 858-5823 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Nothing gets recommended without camera evidence you can look at yourself, and we’ll tell you plainly when a repair can safely wait.
Written by the team at Chimney Sweep Crown Heights.