Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Inspection Across Kensington
If you own or rent in Kensington, you already know that a chimney here is rarely just your chimney. On block after block of attached brick rowhouses, one stack serves more than one address, and what happens on one roof shows up on the next. That’s why a chimney inspection in Kensington has to read the whole stack, not just the firebox in your living room. We’re Chimney Sweep Crown Heights, and our chimney inspection team works Kensington regularly, from the two- and three-family rowhouses off Church Avenue to the low-rise apartment buildings near the Parade Grounds. Every inspection starts with camera evidence you can see and ends with a written report, plus a flat-price scope agreed before any repair is booked. Call (833) 858-5823 to set one up. We answer 24/7.
Why Kensington Homeowners Call Chimney Sweep Crown Heights for Chimney Inspection
Kensington is a densely packed, largely pre-war corner of Brooklyn, and the housing stock tells the story: early-1900s brick rowhouses, two- and three-family homes, and low-rise apartment buildings, many still venting gas-fired heating systems through original masonry chimneys. The work here is less about creosote from wood fires and more about aging brick flues, debris and animal nesting, and liner integrity in century-old stacks. That’s the kind of inspection our technicians are trained for, and our technicians have up to 10 years of experience working in exactly this housing.
We’re a chimney and fireplace specialist, not a general handyman. Every tool and material we bring is chosen for flue environments, and we work with professional-grade brands like HeatShield and DuraFlex when a flue needs resurfacing or relining. When we inspect, we don’t just clean and leave; we tell you what we found, show you the photos, and say plainly when a repair can safely wait. Our local pros are licensed and insured as their state requires, and the estimate is free.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Inspection Services in Kensington
Level 2 Inspection
For most Kensington rowhouses, a Level 2 inspection is the right starting point. It goes beyond the visible portions of the flue and includes the attic, the roof, and a camera run through the flue itself. In an attached house where a neighbor’s appliance may vent into the same stack, this is how you find out what’s actually sharing your chimney.
Camera Inspection
A brush can’t see a cracked clay tile liner. A camera can. We run a camera through the flue and record what it finds, so you’re looking at the same footage we are rather than taking a verbal report on faith. In century-old Kensington stacks venting a gas boiler, this is often the step that catches a deteriorated liner before it becomes a carbon-monoxide concern.
Flue Inspection
Flue inspection focuses on the passage itself: liner condition, blockages, nesting, and how well draft is moving through the stack. Moisture and draft pressure in dense attached housing can accelerate spalling and liner deterioration, so a flue that looks fine from the firebox can be failing a few feet up. We check the whole run, not just the part you can reach.
Level 1 Inspection
A Level 1 inspection covers the readily accessible portions of the chimney and is the right call when the system is in known good shape and you just want an annual check. It’s quick, and it’s a sensible baseline for a Kensington home where nothing has changed and nothing is venting differently than last year.
We also offer Level 3 inspection and real estate inspection for Kensington buyers, sellers, and attorneys who need a documented read on a shared stack before closing.
Trusted Brands We Service in Kensington
When an inspection turns up a problem that needs a fix, we source materials from a vetted roster of professional-grade brands: HeatShield for ceramic flue resurfacing, DuraFlex for flexible liner systems, and Famco and Copperfield for caps and related components. These are the same lines used by certified chimney professionals nationwide, and they’re engineered for flue environments rather than repurposed from general contracting. We don’t stock parts on a truck or claim a warehouse; when a repair is agreed, we order what the job calls for and schedule the work. That keeps the turnaround honest and the materials right for your stack.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Inspection Problems We See in Kensington Homes
- A cleaning called when the real issue is a liner. Many Kensington homeowners book a sweep for a gas boiler flue, when the actual problem is a cracked or deteriorated clay tile liner in a century-old stack. A brush won’t catch that; a Level 2 camera inspection will.
- Cross-contamination on a shared stack. Where a neighbor’s appliance vents into the same brick stack across a party wall, a draft or CO issue can be nearly impossible to trace to its source without inspecting the neighboring flues too.
- Damp staining treated as a one-house fix. Water entering through a spalled crown or failed flashing on an attached neighbor’s portion of a shared stack often surfaces two doors down, so a single flashing repair misses the actual entry point.
- Freeze-thaw damage above the roofline. A humid, four-season climate with cold winters and hot summers cycles exposed brick crowns and flashing, and moisture working into the stack accelerates spalling and liner wear over time.
In a typical Kensington two- or three-family rowhouse, a homeowner calls after noticing damp staining on an interior wall or a musty smell near the boiler flue. The cause usually traces to a spalled crown or failed flashing on the exposed brick stack above the roofline, letting freeze-thaw moisture into a decades-old clay tile liner. Because the stack is tied into a party wall, a qualified local pro typically runs a Level 2 camera inspection of the flue, checks the smoke chamber, damper and cap, and confirms whether a neighbor’s appliance is venting into the same shared stack, then reports what needs repointing, relining or re-crowning before it becomes a carbon-monoxide or chimney-fire risk.
Pricing for Chimney Inspection in Kensington, NY
Pricing here is per job, set by a written estimate, and the estimate is free. Typical ranges for Kensington:
- Level 1 inspection: typically $150 to $250
- Level 2 inspection with camera: typically $250 to $450
- Level 3 inspection: typically $400 and up, depending on access
- Camera inspection of a single flue: typically $125 to $250
Roof access on a tight attached block, the number of flues in a shared stack, and whether the inspection is for a real estate transaction all move the estimate. We agree the scope before booking, and nothing is recommended without camera evidence you can see yourself.
We Also Serve Cities Near Kensington
Kensington sits close to Flatbush, Flatlands, East Flatbush, and Park Slope, and we work those neighborhoods too. They share much of the same pre-war brick and attached rowhouse stock, so the same shared-stack logic applies. If you’re a few blocks over the line, call us and we’ll book you in.
Serving Kensington, NY – Our Local Coverage Area
We serve Kensington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Inspection in Kensington
Yes. A gas boiler chimney still needs inspection, because the flue liner and draft path carry combustion gases and can degrade in a century-old stack just like a fireplace flue. A cracked liner or blocked flue on a boiler vent is a real carbon-monoxide concern, which is exactly why we run a camera through it. Call (833) 858-5823 for a free estimate.
It happens because attached rowhouses on many Kensington blocks share brick party-wall stacks, so a spalled crown or failed flashing on one portion of the stack lets water travel into the shared masonry and show up as staining two doors down. That’s why our inspection reads the neighboring flues, not just the one you called about. Call (833) 858-5823 to book an inspection.
A Level 1 covers readily accessible portions; a Level 2 adds the attic, roof, and a camera run through the flue; a Level 3 opens concealed areas when a serious problem is suspected. For most Kensington rowhouses with a shared stack, a Level 2 is the right starting point. Call (833) 858-5823 for an exact quote.
A camera inspection is the reliable way, because it lets us trace the flue paths inside the stack and see whether a neighbor’s appliance connects into the same run. A visual check from the firebox alone won’t show it. If you suspect it, call (833) 858-5823 to set up a Level 2 inspection.
In most cases yes. Third-degree creosote is the hardened, glazed stage, and it takes more than a standard sweep; it often calls for chemical treatment or mechanical removal before relining. If the camera shows it, we’ll show you and quote the fix. Call (833) 858-5823 for a free estimate.
Whether you’re on a busy rowhouse block off Church Avenue or in a low-rise building near the Parade Grounds, a proper inspection protects the whole stack, not just your fireplace. Call (833) 858-5823 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Crown Heights.